Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Pressing on the Output button (1) several times allows you to set another
output: 2200W→1300W→900W (Switzerland: 2000W→1200W→800W). When
heating, you can switch on air circulation using the ventilator button (5); this will
ensure the heat is distributed quicker. Pressing this button again will switch the
fan off.
Pressing on the output button once again will turn on the frost-protection
setting: the thermostat will set to 7°C automatically, the frost icon will appear
and if the fan was on, this will switch off. If the temperature falls under 5°C, the
device will start to work on low power.
If you press the output button again, the device will switch back to 2200W
(Switzerland: 2000W) without fan option and the process will repeat.
You can use the higher/lower buttons (6 and 7) to increase/decrease the set
temperature. The device has a thermostat and will provide heat until the set
temperature is reached. The temperature will then be maintained; the device
will switch itself back on automatically if the temperature drops by 2°.
The number of hours the device stays on can be set using the timer button. 1x
press = 1 hr, 2x presses = 2 hrs and so on until max. 15 hours. The display will
show the set number of hours. Pressing this button again will switch the timer
off.
Pressing the Celsius↔Fahrenheit button will change the display from ºC to ºF
and vice versa.
Press the stand-by button again in order to switch off. Then press the ON/OFF
switch to OFF and remove the plug from the socket.
is at least 2° higher than the current temperature (left on the display)!
Safety features
Tipping safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning,
but have it inspected/repaired!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the heater has cooled down
sufficiently, it will in principle start again automatically, however if you do not
remove the cause of the cut-off then this will probably be repeated. Regular
NB: the device will only provide heat
if the set temperature (right on the display)
37
Advertenties
Inhoudsopgave
