Advertenties
Beschikbare talen
Beschikbare talen
Possible misuse
• Do not use this hand-held product clamped in a fixed position or as a stationary device.
• Do not use the product in heavy rain or under water.
Status indicators of the Liion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶
If the release button is pressed with a battery inserted in the product, subsequently check that the battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product is switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
Two (2) LEDs show constantly green
One (1) LED shows constantly green
One (1) LED slow-flashes green
One (1) LED quick-flashes green
One (1) LED quick-flashes yellow
One (1) LED shows yellow
One (1) LED quick-flashes red
Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than three seconds. The system does not detect a
potential malfunction of the battery due to misuse, for example battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1) LED showing con-
stantly green.
All LEDs show in sequence, followed by one (1) LED quick-flashing
yellow.
All LEDs show in sequence, followed by one (1) LED showing con-
stantly red.
Items supplied
Cutting tool, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at: www.hilti.group
Technical data
Product generation
Rated voltage
Weight in accordance with EPTA Procedure 01
Max. cable diameter
Max. cutting capacity
Storage temperature
Ambient temperature for operation
14
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
State of charge: < 10 %
The Li-ion battery is completely discharged. Recharge the battery.
If the LED again starts quick-flashing after the battery has been
charged, consult Hilti Service.
The Li-ion battery or the product in which it is inserted is overload-
ed, too hot or too cold, or experiencing some other fault.
Bring the product and the battery to the recommended working
temperature and do not overload the product when it is in use.
If the message persists, consult Hilti Service.
The Li-ion battery and the product in which it is inserted are not
compatible. Consult Hilti Service.
The Li-ion battery is locked and cannot be used. Consult Hilti Ser-
vice.
Meaning
The battery can remain in use.
The check to ascertain the battery's state of health did not com-
plete. Repeat the procedure, or consult Hilti Service.
If a connected product can still be used, the remaining battery ca-
pacity is below 50 %.
If a connected product can no longer be used, the battery has
reached the end of its useful life and has to be replaced. Consult
Hilti Service.
HS Guy Wire
EHS Guy Wire
02
21.6 V
3 kg
45 mm
15.9 mm
13 mm
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
*2321709*
2321709
Advertenties
