Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Translation of the original instructions
t
4T LOG MODE
Main button
T1
T2
<0.5s
t
Main button
T1
T2
or
Secondary button
For this mode it may be convenient to use the dual button torch option or dual button with potentiometer. The "up" command keeps the same function
as the single button or trigger torch. The secondary button can, when pressed, switch to the cold current. The welding torch potentiometer, when
present, allows the welding current to be adjusted from 50 % to 100 % of the setpoint.
COMMAND TRIGGER CONNECTOR
DB
P
L
Cabling diagram for the SRL 18 torch.
Torch with 2 triggers +
potentiometer
Up
Down
DB
Up & Down torch wiring diagram
PROTIG 201 AC/DC - 201L AC/DC
t
T4
T3
<0.5s
>0.5s
t
T4
T3
P
torch
L
torch
Torch type
Torch with 1 trigger
Torch with 2 triggers
1
5
Up & Down
2
4
DB
2
3
T1: The main button is pressed, the cycle starts at PreGas and stops
in the I_Start phase.
T2: The main button is released, the cycle continues in UpSlope and
in welding.
LOG : this mode is used during welding :
- A brief press of the main button (<0.5s), the current switches
from I welding current to I cold and vice versa.
- The secondary button is kept pressed, the current switches from I
welding to I cold.
- The secondary button is released, the current switches from I cold
to I welding.
T3: A long press on the main button (>0.5 sec.), the cycle switches
to DownSlope and stops in the I_Stop phase.
T4: The main button is released, the cycle ends with PostGas.
DB
torch
NC
Electric diagram based on type of torch used.
Wire description
Common/Earth
Switch trigger 1
Switch trigger 2
Common/ Potentiometer
4
3
5
2
6
1
NC
DB torch
L torch
DB + P
torch
Pin
2 (green)
4 (white)
3 (brown)
2 (grey)
earth
10 V
1 (yellow)
Cursor
5 (pink)
Switch 1
Switch 2
Switch Down
Switch Up
Up & Down torch electrical diagram
EN
4
3
2
2
5
1
29
Advertenties
Inhoudsopgave
