Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MODELS INCLUDING BATTERIES
Warranty
Warranty (warranty service) does not include the battery.
The gas hob manufacturer is exempt of any responsibility for the malfunction of batteries.
Package
Some models include batteries (D or LR20 or R20S type; 1,5 V) for the
autoignition function. Capacity (device) to install the battery located
at the bottom back left side of the hob as shown in the picture.
If the battery is not included and should be purchased separately.
Installation and efficiency
Before installing your hob on a tabletop, first insert a battery (checking "+" and "-") into a special device located at the
bottom back left side of the hob as shown in the picture.
Before final fixation of the hob in a tabletop with special sealer (liner) with adhesive basing (included) make sure
autoignition works correctly. In order to do it, push any knob turning it counterclockwise so that its index points at the
flame symbol waiting until there are sparks followed by characteristic cracks (clicks).
In case that autoignition doesn't work properly, check if batteries are unloaded and proceed to change it.
If problems aren't solved, call the Customer Service or maintenance.
Maintenance
Gas/Electrical
Prior to any operation, disconnect the appliance from the electrical system.
For long-life to the equipment, a general cleaning operation must take place periodically, bearing in mind the following:
• the glass, steel and/or enamelled parts must be cleaned with suitable non-abrasive or corrosive products (found on
the market). A void chlorine-base products (bleach, etc.);
• avoid leaving acid or alkaline substances on the working area (vinegar, salt, lemon juice, etc.).
• the wall baffle and the small covers (mobile parts of the burner) must be washed frequently with boiling water and
detergent, taking care to remove every possible encrustation. Dry carefully and check that none of the burner holes
is fully or partially clogged;
• the electrical parts are cleaned with a damp cloth and are lightly greased with lubricating oil when still warm.
• the stainless steel grids of the working area, after having been heated, take on a bluish tint which does not
deteriorate the quality. To bring colour back to its original state, use a slightly abrasive product.
N.B.: - Cleaning of the taps must be carried out by qualified personnel, who must be consulted in case of any fimctioning
anomaly.
Check periodically the state of conservation of the flexible gas feed pipe. In case of leakage, call immediately the
qualified technicians for its replacement.
32
Advertenties
Hoofdstukken
Inhoudsopgave
