Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTRUCTIONS FOR USE
Installation
All the operations concerned with the installation (electrical connection) must be carried out by qualified technicians, in
terms with the standards in force, for specific instructions, kindly read the part reserved for the installation technician.
Use
Gas burners (fig. 1).
The ignition of the gas burner is carried out by putting a small flame to the upper part holes of the burner, pressing
and rotating the corresponding knob in an anti-clockwise manner, until the maximum position has coincided with the
marker. When the gas burner has been turned on, adjust the flame according to need. The minimum position is found
at the end of the anti-clockwise rotation direction.
In models with automatic ignition, operate the knob as described above, pressing simultaneously, the corresponding
push-button. For models with automatic/simultaneous (with one hand) ignition, it is sufficient to proceed as described
above using the corresponding knob. The electric, spark, between the ignition plug and the burner provides the ignition
of the burner itself After ignition, immediately release the push-button and adjust the flame according to need.
For models with a thermoelectric safety system, the burner is ignited as in the various cases described above, keeping
the knob fully pressed on the maximum position for approximately 3/5 seconds. After releasing the knob, make sure
the burner is actually lit.
N.B.: - we recommend the use of pots and pans with a diameter matching that of the burner, thus preventing the flame
from escaping from the bottom part and surrounding the pot
- do not leave any empty pots or pans on the fire
- do not use any tools for grill-cooking on Crystal hobs.
When cooking is finished, it is also a good norm to close the main gas pipe tap and/or cylinder.
GAS
* with reduction grid
Fig. 1
Ф 20 x 26
fast
Ф 14 x 20
semifast
Ф 10 x 14
auxiliary
fish*
31
20 x 32
Advertenties
Hoofdstukken
Inhoudsopgave
