Before use
Unpacking
Remove the packaging. Check if the product is
damaged.
Assembly
Accessory needed: Cross head screwdriver
Number of persons needed for assembly: 1 adult
Fig. Step
1. Remove the 4 lock screws
cross base
[
B
2. Place both parts of the cross base
the floor so they resemble the shape of a
cross.
1. Remove the pole cover
pole
.
[
]
C
2. Loosen the height adjustment lock
the extension pole
3. Pull out the extension pole
1. Place the lower pole
D
base
.
[
]
2. Tighten with the 4 lock screws
1. Insert the pole cover
pole
until it hits the bottom.
[
]
E
2. Tighten the height adjustment lock
the desired height.
1. Remove the grille lock nut
motor unit
[
6 ]
F
2. Attach the rear grille
unit
.
[
6 ]
3. Tighten with the grille lock nut
1. Place the blade
G
2. Tighten with the blade lock nut
18 GB/IE
from the
[
]
.
]
[
from the lower
[
]
[
.
[
]
.
[
]
on the cross
[
]
.
[
]
into the lower
[
]
[
from the
[
4 ]
.
to the motor
[
5 ]
.
4 ]
[
on the motor shaft
[
3 ]
.
2 ]
[
Fig. Step
1. Open the 4 grille clips on the front
grille
2. Remove the lock screw and the lock
nut
3. Hang the hanger of the front grille
the rear grille
H
4. Insert the lock screw
nut
frame.
NOTE: The 4 grille clips must fit over the
frame of the rear grille
on
]
1. Place the motor unit
panel
I
2. Align the hole on the back side.
3. Tighten with the lock screw
on
]
Height adjustment
Loosen the height adjustment lock
on the extension pole
direction.
Adjust the length of the extension pole
Tighten the height adjustment lock
clockwise direction.
Tilt adjustment
at
]
Adjust the tilt angle manually.
Do not perform the tilt adjustment when the
product is in operation.
NOTE: Do not remove the lock screw
adjusting the tilt angle.
.
[
]
.
1 ]
[
from the front grille
[
]
.
5 ]
[
. Fasten the lock
[
]
. Close the 4 grille clips at the grille
[
]
[
5 ]
with speed button
6 ]
[
on the extension pole
8 ]
[
) in a counter-clockwise
[
]
.
[
1 ]
on
[
1 ]
.
.
[
]
.
[
9 ]
(positioned
[
]
.
[
]
in a
[
]
when
[
9 ]