Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION | INSTALLATION
Safety
1.3
Information on the appliance
Connections
Symbol
Meaning
Supply / Inlet / Flow
Drain / Outlet / Return
Heat pump
Central heating
1.4
Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
2.
Safety
2.1
Intended use
This appliance is designed to extend the operating time of the heat
generator and to bridge power-OFF periods. The heat pump buffer
cylinder also provides hydraulic separation of the flow rates in the
heat pump circuit and the heating circuit.
Observation of these instructions and of instructions for any ac-
cessories and other system components used is also part of the
correct use of this appliance.
Any other use beyond that described shall be deemed inappro-
priate. Using the appliance for heating fluids other than water
or for water supplemented with chemicals, such as brine, is also
deemed inappropriate.
3.
Appliance description
The steel cylinder with directly applied foam insulation is equipped
with a protective cover, connections for ventilation and draining,
and a sensor pipe. The hydraulic connections are routed through
the top.
4.
Troubleshooting
Call your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000):
www.stiebel-eltron.com
INSTALLATION
5.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
5.1
General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
5.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
6.
Appliance description
6.1
Standard delivery
The following are delivered with the appliance:
- 3 adjustable feet
000000-0000-000000
Made in Germany
SBP 100 classic |
9
Advertenties
Hoofdstukken
Inhoudsopgave
