Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
This band contains small parts. Always keep small parts away from children to avoid a choking hazard that
could result in personal injury or death.
You can fuse the ends of the bungee cord by melting it or by using heat shrink in a well-ventilated area. Do not
use open flame to fuse the ends of the cord, and do not fuse the ends of the cord near clothing or bare skin, as
doing so could result in property damage or serious personal injury.
The user should never cut the bungee cord while it is on the user's wrist, as this could result in property damage
or personal injury.
It is the user's responsibility to ensure the bungee cord straps are cut to the appropriate length and that an
appropriate knot is tied to ensure the watch remains attached to the wrist. Garmin
loss or damage to a watch resulting from the watch coming off the wrist.
Installing the Bungee Mount
1 Remove the QuickFit
®
2 Cut a piece of bungee cord that is long enough to wrap around your wrist, plus approximately 5 cm (2 in.) to
allow for tying the knots.
3 Thread the cord through two holes on one side of the QuickFit adapter.
4 Tie an overhand knot, and tighten the knot by applying tension to both ends.
The finished knot should prevent the cord from slipping through the adapter holes.
TIP: If preferred, you can tie a figure eight knot instead.
2
QuickFit
Installation Instructions
bands from the watch.
Bungee Mount
®
WARNING
CAUTION
NOTICE
is not responsible for any
®
Installation Instructions
Advertenties
Inhoudsopgave
