Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Removing the insulation
The insulation can be removed, to facilitate handling in
confined spaces (the diameter of the water heater dia-
meter without insulation is Ø 670 mm for EKS 500, Ø
770 for EKS 1000).
1. Remove all screws along the joining plates.
2. Lift off the top cover, on EKS 500 the lifting eye in
the top must be unscrewed first.
3. Pull the insulated jacket halves straight off.
Carry out assembly in reverse order. If the screws are
difficult to fit in the old holes, the joining plate can be
turned upside down, which produces new holes in the
insulated jacket halves.
The figure shows EKS 1000 with insulation.
insulation removed
EKS 500, 1000 L | GB
21
Advertenties
Inhoudsopgave
