Advertenties
Beschikbare talen
Beschikbare talen
Clean the Pressure Roller
A soiled pressure roller can lead to reduced print quality and
can affect transport of material.
CAUTION!
Pressure roller can be damaged!
Do not use sharp or hard objects to clean the
pressure roller.
Clean the Printhead
Printing can cause accumulation of dirt at printhead e.g. by
colour particles of transfer ribbon, and therefore it is
necessary to clean the printhead in regular periods depending
on operating hours, environmental effects such as dust etc.
CAUTION!
Printhead can be damaged!
Do not use sharp or hard objects to clean the
printhead.
Do not touch protective glass layer of the
printhead.
Clean the Label Photocell – Compa V 10X
CAUTION!
Label photocell can be damaged!
Do not use sharp or hard objects or solvents to clean the label photocell.
The label photocell can be soiled with paper dust. This may affect the label scanning.
A
B
C
•
Open the printer cover.
•
Remove the labels and transfer ribbon from the label printer.
•
Loosen the screw (B).
•
Press the button (A) and slowly pull the label photocell outwards via the handle (C). Ensure that the label sensor cable is
not tensioned by this.
•
Clean the label photocell and sensor slots (D) with brush or cotton swab soaked in pure alcohol.
•
Push the label photocell back with the handle (C) and set it.
•
Reload labels and transfer ribbon.
•
Close the printer cover.
•
Open the printer cover.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove the labels and transfer ribbon from the label
printer.
•
Remove deposits with roller cleaner and a soft cloth.
•
If the roller appears damaged, replace it.
•
Reload labels and transfer ribbon.
•
Turn the lever clockwise to lock the printhead.
•
Close the printer cover.
•
Open the printer cover.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove the labels and transfer ribbon from the label
printer.
•
Clean the printhead surface with a special cleaning pen
or a cotton swab dipped in pure alcohol.
•
Before using the label printer, let the printhead to dry for
about two to three minutes.
•
Reload labels and transfer ribbon.
•
Turn the lever clockwise to lock the printhead.
•
Close the printer cover.
D
English
Compa V
123
Advertenties
Hoofdstukken
