Advertenties
Beschikbare talen
Beschikbare talen
Compa V
Cleaning
DANGER!
Risk of death by electric shock!
Before opening the housing cover, disconnect the label printer from the mains supply and wait for a moment
until the power supply unit has discharged.
CAUTION!
Risk of injury when cleaning.
Pay attention to sharp edges.
NOTICE!
When cleaning the label printer, personal protective equipment such as safety goggles and gloves are
recommended.
NOTICE!
For adjustments and simple installation work, use the accompanying hexagonal wrench located in the upper section
of the print unit.
No other tools are required for the work described here.
Cleaning task
General cleaning.
Clean the pressure roller.
Clean the printhead.
Clean the label photocell.
NOTICE!
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure
good ventilation.
WARNING!
Risk of fire by easily inflammable label soluble!
When using label soluble, dust must be completely removed from the label printer and cleaned.
General Cleaning
CAUTION!
Abrasive cleaning agents can damage the label printer!
Do not use abrasives or solvents to clean the outer surface of the label printer.
Remove dust and paper fuzz in the printing area with a soft brush or vacuum cleaner.
Clean outer surfaces with an all-purpose cleaner.
122
Frequency
As necessary.
Each time the label roll is changed or when the printout and
label transport are adversely affected.
Direct thermal printing:
Each time the label roll is changed.
Thermal transfer printing:
Each time the transfer ribbon is changed or when the printout
is adversely affected.
When the label roll is changed.
English
Advertenties
Hoofdstukken
