Advertenties
Beschikbare talen
Beschikbare talen
Set the Label Photocell
A
B
Set the Head Locking System
The printhead is pushed on via two plungers. The location of the outer plunger must be set to the width of the label medium
used so as to:
•
achieve even print quality across the entire label width,
•
prevent wrinkles in the feed path of the transfer ribbon,
•
prevent premature wearing of the pressure roller and printhead.
A
•
Loosen the threaded pin (A) at the right plunger (B) with an Allen key.
•
Position the right plunger (B) over the right label edge.
•
Tighten the threaded pin (A).
C
D
B
The label sensor can be shifted perpendicular to the direction
of paper flow for adaptation to the label medium. The sensor
unit (A) of the label sensor is visible from the front through the
print unit and is marked with an indentation in the label sensor
retainer.
Unscrew the screw (C).
Position the label sensor with tab (D) in such a way that
the sensor (A) can detect the label gap or a reflex or
perforation mark.
If the labels deviate from a rectangular shape:
Align the label sensor using the tab (D) with the front
edge of the label in the direction of paper flow.
Tighten the screw (C).
For use in tear-off mode only:
Turn the lever (B) clockwise to lock the printhead.
English
Compa V
103
Advertenties
Hoofdstukken
