CONTROLS
The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights.
T1. Fan motor OFF / Decrease speed
T2. Fan motor ON / Increase speed
T3. "POWER BOOST " Function
T4. 6th sense function (AUTO mode) ON/OFF
T5. Operation "ZEN Mode"
T6. Grease/charcoal filter alarm/reset
T7. Main light ON / OFF
CAUTION! This hood has an automatic operation system (see below "T4. 6th sense function (AUTO mode) ON/OFF").
Calibration occurs automatically each time the hood is reconnected to the electrical network (e.g.: the first time it is installed after a
blackout).
It can also be performed manually (see paragraph "Sensor set up").
During calibration, which lasts for 5 minutes, T4 will flash and lights can be used.
T1. FAN MOTOR OFF / DECREASE SPEED
Press to decrease speed and switch the extraction motor OFF. Press and hold to directly switch the extraction motor OFF.
T2. FAN MOTOR ON / INCREASE SPEED
Press to switch the extraction motor ON and increase speed. Press and hold to set 3th speed directly.
T3. "POWER BOOST " FUNCTION
Press T3 to activate the "POWER BOOST 1" intensive extraction speed (time-controlled).
Please note: the hood will go back to running at the 3th speed, after five minutes.
With the extraction motor on, in "POWER BOOST1", press again T3 to activated the "POWER BOOST 2" additional intensive
extraction speed (time-controlled).
Please note: the hood will go back to running at the 3th speed, after five minutes.
Please note: press again T3, during the five minutes, the hood will go back to running in "POWER BOOST 1"
T4. 6TH SENSE FUNCTION (AUTO MODE) ON/OFF
The hood set the extraction speed automatically if the sensor in the hood detects changing on ambient conditions.
Please note: to make sure this function is used correctly first configure sensor (see "Sensor set up" below).
Please note: if you change any other functions that control the speed, the "6th sense" function will switch off.
Sensor set up
This can be done when the hood is OFF.In normal ambient conditions press T4 for 5secs, T4 flashes for 5 mins to indicate hood is
performing sensor calibration, then switches off to indicate the calibration has ended.
Setting cooktop: Press and hold T1 and T2 simultaneously. Both lit to indicate hood is ready to accept cooktop parameter
calibration.
Press T1 to choose Gas hob (T1 starts to flash for 3 secs to indicate hood parameters are set for gas hob).
Press T2 to choose Induction hob (T2 starts to flash for 3 secs to indicate hood parameters are set for induction hob).
T5. OPERATION "ZEN MODE"
Press to activate or deactivate the "ZEN" extraction mode.
This function makes it possible to activate an extraction speed with the perfect balance between quietness and extraction efficiency.
T6. GREASE/CHARCOAL FILTER ALARM/RESET
At regular intervals, the hood signals the need to perform filter maintenance.
Please note: The indicators will only work when the hood is on.
12