Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Checking the air pressure with the Mini-Compressor
PLEASE NOTE: The pressure gauge with pressure display
Mini-Compressor
Connect the inflatable item to the connecting valve
„
, whose pressure you want to check. To do so, please proceed as described
1
in the section "Connecting the compressed air hose with a valve adapter" or
"Connecting the compressed air hose without a valve adapter".
The pressure gauge with pressure display
„
inflatable item connected.
Disconnect the inflatable item from the connecting valve
„
Compressor
"Removing the compressed air hose".
PLEASE NOTE: When disconnecting the connecting valve
escape from the valve on the inflatable item. Ensure that you remove the
connecting valve
z Replacing the fuse
Never use a fuse with a higher release current strength.
There is a risk of fire!
ATTENTION: You must not use a fuse with a different release current
strength compared with the pre-installed fuse! Before switching the device back
on, ascertain why the fuse tripped.
In order to replace the 10 A glass fuse
as follows:
Unscrew the fuse screw plug
„
When doing this, make sure you do not lose the loosely inserted contact pin
„
and spring
16
Remove the defective 10 A glass fuse
„
Put the spring
„
plug
. Then insert a new 10 A glass fuse of equal value.
7
Now insert the contact pin
„
screw plug
17
is not trade-approved.
1
. To do so, please proceed as described in the section
1
as quickly as possible.
4
17
.
14
(if it has been removed) back into the 12 V cigarette lighter
14
into the fuse screw plug
16
back onto the 12 V cigarette lighter plug
shows the pressure of the
2
in the cigarette lighter plug
15
. The fuse is located below this plug. See Fig. G.
.
15
GB/IE/NI
of the
2
of the Mini-Compressor
4
of the Mini-
4
, air can
4
, proceed
7
and screw the fuse
17
.
7
17
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
