For the device to operate properly, the socket for the electrical system must have
a voltage between 10.5 V and 14.8 V. Before connecting the device, check
whether the voltage supply provides sufficient power for operation.
z Using the Mini-Compressor
Place the product on a level and non-flammable surface.
Do not cover the ventilation openings.
Do not operate the device in a dusty environment. This is a fire risk and the
device could be damaged.
A gap of at least 50 cm must be maintained behind the ventilation slots of the
compressor.
Make sure that the product is switched off.
Connect the cigarette lighter plug
PLEASE NOTE: You can use the connecting valve
with the valve adapters
Connecting the compressed air hose without a valve
adapter.
Undo the connecting valve
(see Fig. C for position).
Now push the connecting valve
(remove valve cap on the inflatable item first if necessary).
Then push the clamp lever
holding the valve firmly.
Connecting the compressed air hose with a valve
adapter
The valve adapters
See Fig. H.
First fit the required valve adapter
Push the clamp lever
Connect the valve adapter
inflatable item (remove valve cap on the inflatable item first if necessary).
Removing the compressed air hose
Connecting without the valve adapters
to an open position (Fig. C) and pull the connecting valve
item.
Connecting with the valve adapters
from the connecting valve of the inflatable item. Move the clamp lever
to the 12 V socket of the cigarette lighter.
7
,
,
supplied.
11
12
13
by pushing the clamp lever
4
over the valve of the inflatable item
4
back down (see Fig. D for position) while
5
,
and
are located on the side of the device.
11
12
13
,
11
downwards to fix the valve adapter in place (Fig. D).
5
,
or
11
12
11
4
or
onto the connecting valve
12
13
to the connecting valve on the
13
,
or
: Move the clamp lever
11
12
13
,
or
: First undo the valve adapter
12
13
GB/IE/NI
directly or together
upwards
5
off the inflatable
4
5
15
.
4
5
to