Advertenties
Beschikbare talen
Beschikbare talen
Assembly
■
Keep the working area free from material to
be shredded and other objects – danger of
stumbling.
■
The user of the machine is responsible for
accidents involving other persons or their
property.
■
Ensure good lighting of the working area.
Operating times:
■
When operating in residential areas, observe
country-specific and communally permitted
operating times according to the regulations
on noise pollution.
■
Work with the machine in daylight or with
good lighting only.
Operation:
■
Do not reach into the hopper or feed chute
during operation!
■
The cutting disk after-runs after the machine
is switched off!
■
Only put the machine into operation when as-
sembly has been completed.
■
Always perform a visible inspection prior to
using the machine. The machine must be in a
safe operating condition.
■
Never work alone.
■
Immediately renew damaged or worn parts.
■
Only use the machine if it is in the technical
condition stipulated by the manufacturer.
■
Do not undertake shredding work in the rain,
snow, stormy weather or during thunder-
storms (danger of lightning!). Do not use the
shredder in wet or damp surroundings.
■
Do not deactivate safety and/or protective de-
vices on the machine.
■
Always ensure that the machine is stable be-
fore starting work.
■
Never transport the shredder with the motor
running.
■
Never transport the shredder with open or
unlocked shredder upper section.
■
Switch the motor off, wait for the cutting disk
to stop moving, and disconnect the machine
from the mains connection prior to moving
the machine.
■
When moving the shredder, only transport it
using its handle.
■
Always ensure a stable stance when working.
Do not bend forward too far.
443093_c
■
Do not feed the shredder from an elevated
position.
■
Always disconnect the shredder from the
mains power supply when not in use.
In the event of a malfunction or accident:
■
Immediately disconnect the mains plug from
the mains if the mains cable has been dam-
aged or severed!
■
If a foreign object is drawn in or in the event
of unusual noises or vibrations, immediately
switch off the shredder and disconnect it from
the mains. Then proceed as follows:
■
Inspect the damage.
■
Refasten loose parts, e.g. tighten screws.
■
Have all damaged parts exchanged or re-
paired by our customer service.
5 ASSEMBLY
CAUTION! Danger of injury if the ma-
chine is incomplete! Incomplete machines can
lead to injuries and damage to the machine!
■
Do not operate the machine until it has been
fully assembled.
5.1
Mounting the chassis (03)
1. Push (03/a) the ends of the bases (03/1) into
the frame connection (03/2).
2. Position the axle tube (03/3) between the
bases.
5.2
Mounting the transport wheels (04)
1. Slide the wheel shaft (04/1) into the base.
2. Next, slide a large washer 10x20x1.5 (04/2)
and the bushing (04/3) onto the shaft.
3. Afterwards, slide the transport wheel (04/4)
onto the bushing.
4. Place the washer 8x20x1.5 (04/5) onto the
thread and secure the transport wheel using
an M8 nut (04/6).
5. Press the wheel cap (04/7) onto the transport
wheel.
6. Fit the opposite transport wheel in the same
sequence.
5.3
Mounting the pedestals (05)
1. Turn the transport frame around.
2. Attach the pedestals (05/a) to the transport
frame using the screws (05/1).
21
Advertenties
