Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
4.1 Adding a remote control
Keygo io:
see figure 5
[1]. Press the PROG 1 button on the receiver for 2 seconds.
‣Indicator light L1 is lit constantly.
[2]. Press the outer left and right buttons on the Keygo io remote control together; this
must be done within 2 minutes.
‣The remote control indicator light flashes.
[3]. Press the button on the remote control which controls the drive.
‣Indicator light L1 flashes for 5 seconds; the remote control has been memorised.
3-button remote control:
[1]. Press the PROG 1 button on the receiver for 2 seconds.
‣Indicator light L1 is lit constantly.
[2]. Press the "PROG" button on the back of the Telis io; this must be done within 2 minutes.
‣Indicator light L1 flashes for 5 seconds; the remote control has been memorised.
4.2 Clearing the remote controls
See figure 7
Press the PROG 1 button on the receiver for 7 seconds.
‣Indicator light L1 is lit constantly then flashes; all Keygo io and Telis io remote
controls are deleted for relay 1.
4.3 Adding or deleting a Keytis io remote control
See the remote control manual and follow the procedure from the memorising the system
key step.
4.4 Adding or deleting a TaHoma or Connexoon unit
Follow the procedure for adding a product to the TaHoma or Connexoon interface.
Sequential mode:
see figure 8
Automatic mode:
see figure 9
The garage door or gate will close again after the automatic closing timeout configured
on the drive's electronic unit: consult the installation guide if this timeout needs to be
changed.
When the Connexoon "Arriving" mode is activated by means of geotracking, the activation
distance must be consistent with the automatic closing timeout setting.
6
see figure 6
5 - OPERATION
Copyright © 2017 Somfy SAS. All rights reserved.
Advertenties
Inhoudsopgave
