Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Dimensions:
see figure 1
Conditions of use:
see figure 2
Cabled outputs:
• The receiver is fitted with two dry contact relays that are normally open.
• Pressing the programmed button of an io remote control closes the corresponding relay
for one second.
Assembly:
see figure 3
Wiring:
see figure 4
To ensure electrical safety, this class III product must be supplied via a SELV voltage
source (safety extra low voltage).
[1]. Turn off the electric power supply.
[2]. Connect the power supply cable to terminals 1 and 2.
[3]. Connect the aerial cable provided to terminal 8. Do not cut the cable.
If using an external aerial, connect the braid to terminal 7 and the core to terminal 8.
[4]. Connect the receiver output relays to the control inputs on the electronic units of the
drives already installed.
[5]. Switch the power back on.
The cables must be routed through the cable grommets (directed downwards) to ensure
that the unit remains sealed. The cable grommet cut-outs must comply with the
regulations in force.
These instructions describe how to programme the control on relay 1; the procedure is
identical to programme the control on relay 2.
For remote controls with information feedback (Telis io, Impresario Chronis io, etc.), you
must first check that this remote control has memorised the system key (see the remote
control manual).
Copyright © 2017 Somfy SAS. All rights
2 - PRESENTATION
3 - INSTALLATION
4 - PROGRAMMING
reserved.
EN
5
Advertenties
Inhoudsopgave
