Charge With Elvi - EVBOX Elvi Gebruikershandleiding
Verberg thumbnails
Zie ook voor Elvi:
- Installatie- en gebruikershandleiding (40 pagina's) ,
- Installatiehandleiding (30 pagina's) ,
- Installatiehandleiding (26 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Charge with Elvi
Start charging
1.
Plug the Elvi charging cable into your car.
•
If you're using a cable dock (optional) and a Type 1 cable, press the release button on
the cable plug, then release the cable from the dock, and plug the cable into your car.
•
If you're using a cable dock (optional) and a Type 2 cable, press the release button on
the cable dock, then release the cable from the dock, and plug the cable into your car.
2.
To start or stop a charging session, you can use a registered charge card, key fob or your
mobile app for station management.
3.
Hold your charge card (RFID card) in front of the reader where it's marked with a
4.
Elvi reacts with a beep. This means that your card is being authorized.
5.
The Elvi LED ring turns blue when it starts charging.
Stop charging
1.
Hold your charge card (RFID card) in front of the reader where it's marked with a
2.
Elvi reacts with a beep. This means that your charge card/key fob is being authorized. The
Elvi LED ring turns green when it stops charging.
3.
Unplug the Elvi charging cable from your car and place it back into Elvi's cable holder.
Alternatively, you can unplug your charging cable from your car directly and end your
session.
What you see
LED ring off
or green
LED ring
green, flashing
LED ring
yellow
LED ring
yellow, flashing
LED ring
blue
LED ring
red
LED ring
red, flashing
What it means
Elvi is ready for use.
Your charge card is being
verified.
The car is fully charged.
Charging session is in queue
(applicable in the Smart
Charging environment only).
Elvi is charging the car.
Elvi is experiencing
an error.
Your charge card is not
authorized to charge.
What to do
Plug Elvi charging cable into the car.
Wait until LED ring turns blue.
Unplug Elvi charging cable from the car and
place the cable back into Elvi cable holder.
When power becomes available, charging will
start or resume, and the LED ring will turn blue.
The car is charging.
Check the troubleshooting chapter in this manual
for solutions. If this does not solve the issue, con-
tact your installer or supplier of Elvi, or write us at
support@evbox.com.
Contact your charge card service
operator.
EN
icon.
icon.
9
Advertenties
Inhoudsopgave
