Advertenties
Beschikbare talen
Beschikbare talen
Caution:
Avoid overloading the device, an overload can damage the device or cause a short circuit! Therefore,
please note the maximum power consumption in the technical data!
▪
The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer
be guaranteed if it is modified! In addition, this will invalidate the warranty claim!
▪
The manufacture does not accept any responsibility for injuries or damage resulting from improper use of
this product!
▪
Any other use than the description may result in damage to the product. So the dangers are such as
electric shock, short circuit, fire etc.
▪
We reserve the right to make changes to the product, the packaging or the operating instructions as well as
printing errors.
▪
This product is suited for indoor- and outdoor-use.
▪
Protect the product from external damage, heavy dirt, moisture and excessive heat!
▪
In order that the warranty claim does not expire please use only the supplied items. Repairs may only be
done by an expert and only by using original spare parts!
▪
In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Instruction for installation (Fig 4):
Danger:
Before installing please make sure that the circuit is interrupted! For installation, the work on the mains
voltage is required. Please remove the associated mains fuse or deactivate the switch fuse! Check by using a
voltage tester if the line is de-energized. Make sure that the current circuit will not closed during the installation!
Danger:
The installation of this product may be done only by a qualified person according the valid regulations for
electrical installation!
Attention:
Before drilling the mounting holes, make sure that there are no gas, electricity or water pipes at the
drilling location that could be damaged by this!
▪
Please observe the safety instructions and technical data before installing this product!
▪
Note on installation:
L: Live wire (black or brown)
N: Neutral conductor (blue or grey)
▪
This device is suitable for wall or ceiling mounting!
▪
When mounting the unit on the ceiling, mount it at least 1m away from the wall. If the wall is very thin, a
greater distance is recommended. The sensor could also detect movements behind this wall.
▪
Observe a minimum distance of 2 meters when commissioning several motion detectors.
▪
For optimum range, select the mounting height recommended in the "Technical Data".
▪
2 units in a parallel connection (see Fig.3a)
▪
Permanent switch-on of a connected unit with an additional switch connected in parallel (see Fig.3b).
The following environments or surfaces are not suitable for mounting, as they can impair the function of the motion
sensor:
▪
Metal surfaces, for example metal door frames or metal-coated walls
▪
Metal contained in masonry e.g. steel girders
▪
In the immediate vicinity of electronic devices such as computers, monitors etc
▪
Water drainage or supply pipes can trigger a signal when water flows
Function of the motion sensor:
This product is an active motion detector. It generates high-frequency electromagnetic waves (5.8GHz) and then
receives their echo. The motion detector thus reacts to changes in the waves reflected back from objects,
regardless of temperature. As a result, the smallest movements that occur in the detection range of the product can
be detected. The integrated microprocessor triggers the command "Switch on light" almost without delay. This
enables the perception of movements through doors, glass panes or thin walls. Note: The radiation emitted by the
9
Advertenties
