Advertenties
Beschikbare talen
Beschikbare talen
• Operate the nozzle support head (27) as shown in Fig. 7-a and start up the cleaner again by turning the
master switch (1) to "I". Now operate the lever (22): When the water is fed through, suction and mixing
take place automatically. To resume work at high pressure, stop the cleaner by turning the master switch (1)
to "0" and adjust the head (27) as shown in Fig. 7-b (these versions deliver the detergent at low pressure).
NOTE. If the knob for temperature adjustment (35) is in "0" position, the detergent distribution will be
in cold water; if it is in position "I", the detergent distribution will be in hot water.
• Turn the knob (29) until the amount of product required is delivered. AftWhen you have finished using
it, turn the knob (29) completely anticlockwise and, if you were using an external tank for suctioning the
detergent, take the fitting (44) out of the coupling (42) and put the cap (43) back on.
STOPPING THE CLEANER – TOTAL STOP MODE
• Release the cleaner gun lever (22) to stop the high pressure jet; the high pressure cleaner moves to the
by-pass operating mode and stops immediately (single-phase JUPITER models only; Instant Total
Stop), or after approximately 13 seconds it remains in this state (Timed Total Stop).
• The cleaner will resume normal operation the as soon as the lever on the gun is pressed.
WARNING
• If you stop the high pressure jet and put the gun down, enable the locking handle (23). Step S in Fig. 5.
• Run the cleaner for a few minutes with cold water.
• Close the tap on the water supply off completely (or remove the suction pipe from the draft tank).
• Drain the water out of the cleaner by running it for a few seconds with the cleaner gun lever (22) pressed.
• Turn the master switch (1) to "0".
• Take the plug out of the power socket.
• Eliminate any remaining pressure in the high pressure hose (30) by keeping the cleaner gun lever (22)
pressed down for a few seconds.
• Wait for the cleaner to cool down.
• Wind up the high pressure hose (30) with due care, making sure it is not bent; for versions without hose
reel, store it carefully, without damaging it.
• Wind up the power cord (6) carefully and hang it up on its support (10).
• Store the high pressure cleaner in a clean, dry place. Make sure the power cord and the high pressure
hose are not damaged.
• If necessary for space reasons, it is also possible to bend the handle (2): unscrew the screw (19) using an
allen wrench (6 mm / 0,23" ) not supplied, move the handle as in Step G in Fig. 1, then tighten the screw
again to keep the handle in place.
STOPPING
STORAGE
EN
23
Advertenties
