Advertenties
Beschikbare talen
Beschikbare talen
The following range of accessories can be added to the standard equipment supplied with the high
pressure cleaner:
• hose reel;
• cleaner gun with pressure regulator;
• ion acceleration limescale remover;
• sandblasting lance: designed for sanding surfaces, removing rust, paint and lime scale deposits, etc;
• pipe flushing probe: designed for unblocking pipes and ducts;
• rotating nozzle lance: designed for the removal of stubborn dirt;
• foaming lance: designed for a more efficient distribution of detergent;
• various types of lances and nozzles;
• back-flow preventer: designed to comply with the standards relative to connecting to the drinking water
mains;
• rotating brush: conceived for delicately and effectively cleaning large surfaces such as the bodywork of
vehicles;
• exhausted fumes conveyor.
• Connect the quick fit connector (31) on the hose (30) to the water outlet connector (16) and secure the
ring nut tightly by hand. Step B in Fig. 8.
• Screw the connector (37) on the high pressure hose onto the thread of the cleaner gun (24) or (40) and
tighten it using two 22 mm spanners (not supplied). Step A in Fig. 8.
• Insert the filter (18) in the connector (17) and the seal (26) in the hose support (25); screw the hose
support (25) onto the connector (17). Step C in Fig. 8.
• Unscrew the screw (19) using an allen wrench (6 mm / 0,23" ) not supplied, move the handle as in Step
F in Fig. 1, then tighten the screw again to keep the handle in place.
• Use the handles (2) to move the high pressure cleaner to the area where it is to be used.
• Engage the brake (34) on the swivel wheel (33).
• Unwind the high pressure hose completely (30).
• Using the collar clamp (39), secure a supply pipe to the water inlet hose support (25) that has an inside
diameter of 19 mm/0.75 in. Step C in Fig. 8.
• Connect the water supply hose to a tap.
• Open the water tap (if connecting to the mains water supply, you must use a backflow hydraulic device:
please refer to the relative instruction manual), making sure that there is no dripping (or place the suction
pipe in a draft tank).
• Check the detergent adjustment knob (29) is closed properly.
• Check the master switch (1) is set at "0" and connect the plug. Step D in Fig. 8.
• Turn the master switch (1) to "I".
NOTE (three-phase models only): if the warning light (36) is flashing it means you need to contact a
Specialized Technician to reverse the connection of two phases of the high pressure water cleaner plug
or of the socket it is connected to.
• Press the cleaner gun lever (22) and wait for an even stream of water to be produced.
• Turn the master switch (1) to "0" and connect the lance pipe (21) to the cleaner gun (24) or (40), securing
it firmly. Step E in Fig. 8.
OPTIONAL ACCESSORIES
INSTALLATION – FITTING THE ACCESSORIES
PRELIMINARY OPERATIONS
EN
21
Advertenties
