Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
Remote control:
•
Environmental temperature for cooling function: 18°C – 35°C
Environmental temperature for heating function: 15°C – 25°C
•
Make sure that the exhaust hose is installed properly before operation, then plug in the unit, but do not
use a multiple socket. Press „POWER" to turn on the unit. When pressing the button again, the unit will
enter the standby mode.
•
LED display:
o
The LED display indicates the set temperature in °C or the set timer. Possible error codes are
also shown on the LED display.
Operation mode cooling:
•
o
When the refrigeration function is carried out, the exhaust hose should be placed outside the
window so that the hot air can be discharged.
o
Press „MODE" until the indicating light for cooling lights up.
Press the buttons „UP" und „DOWN" to adjust the desired room temperature between 16°C und
o
31°C.
o
For optimal cooling, make sure that curtains are closed to avoid direct sunlight entering the
room. Ensure that the unit is not placed near heat sources.
Operation mode heating:
•
Press „MODE" until the indicating light for heating lights up.
o
o
Press the buttons „UP" und „DOWN" to adjust the desired room temperature between 16°C und
31°C.
Ventilation speed:
•
o
Press the button „SPEED" to adjust the ventilation speed between low, medium, high and auto
mode. The according speed levels are indicated by the indicating lights at the control panel. At
the lowest ventilation level, the unit is operating in "Low Mode" with a reduced noise level.
Note: During dehumidifying function the ventilation speed cannot be adjusted and stays at low
o
speed.
Timer for turning on the unit:
•
Press „TIMER" while the unit is in standby mode and set the desired time at which the unit shall
o
turn on by using the buttons „UP" and „DOWN" between 0 and 24 hours.
o
Select the required function (cooling, heating, dehumification) and set the required temperature.
When the set time has expired, the unit starts automatically.
o
o
If you press „POWER" before the time has expired, the time programming is deleted and the
unit switches back on.
•
Timer for turning off the unit:
o
Press „TIMER" while the unit is operating and set the desired time at which the unit shall turn
off by using the buttons „UP" and „DOWN" between 0 and 24 hours.
o
After the flashing of the number of hours on the LED has stopped, you can select the required
function (cooling, heating, dehumification) and the required temperature.
When the set time has expired, the unit turns off automatically.
o
o
If you press „POWER" before the time has expired, the time programming is deleted and the
unit turns off.
•
Operation mode dehumidifying:
o
Close all doors and windows during this operation mode to ensure no additional humidity will
enter the room. The exhaust hose will not be required in this mode.
o
Press „MODE" until the according indicating light lights up. The display shows „dH".
o
The ventilation speed is set as „LOW" automatically.
1. SPEED:
Ventilation speed
2. TEMP+:
Temperature +
3. MODE:
Operation mode
4. TEMP-:
Temperature -
5. TIMER:
Timer
6. POWER:
On/Off button
Operation with 2 x AAA batteries (excl. scope of delivery)
Advertenties
Inhoudsopgave
