Advertenties
Beschikbare talen
Beschikbare talen
Using the device / Troubleshooting
You can replace the battery, once you
„
have removed the cover of the battery
15
compartment
.
F
z Troubleshooting
Faults
The filter does not become dark
steadily or flickers.
The reaction is slowed down.
Visibility is poor.
The welding helmet slips.
32
GB/IE
15
Cause
The viewing pane 1 is dirty or
defective.
The arc sensor 17 is not clear.
The welding current is too low.
The ambient temperature is too
low/high.
The sensitivity is too low.
The viewing pane 1 /rear lens
4 is dirty.
The protective film on the rear lens
4 has not been removed.
The ambient light is not sufficient.
The wrong darkening level has
been set.
The headband 5 is adjusted
incorrectly.
Then, close the battery compartment
„
In order to close the battery compart-
ment, you must put the lid of the battery
compartment
15
handle downwards until the cover clicks
into place.
Clean the viewing pane or
replace it.
Clean the surface of the arc
sensor 17 .
Set the sensitivity to the max. level.
Only use the welding helmet at
temperatures between -5°C and
+55°C.
Adjust the sensitivity to a higher
level.
Clean the viewing pane 1 /
rear lens 4 .
Remove the protective film.
Provide more light for the working
environment.
Re-set the darkening level.
Re-adjust the headband 5 and
make it tighter.
15
on and then push the
Solution
.
Advertenties
