Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• The installation and assembly of this device in non-stationary setup locations must be carried out
by specialist companies / electricians, provided they guarantee the prerequisites for the safe use
of this device.
• For energy saving reasons please ensure that the door is closed when the appliance is turned on.
11.5.2 The handle
The handle for opening the door is recessed on the upper side of the door.
11.5.3 Wine shelves
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of
the wine shelves can be removed to accommodate larger bottles.
11.5.4 To remove a shelf
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
Please note
► Ensure that the tabs are firmly engaged in place before storing any bottles.
► Any of the wine shelves can be removed to accommodate larger bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.
11.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions must be
observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on the rating
plate with those of your electrical network. This data must agree in order that no damages occur in
the device. If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The connection between the device and the electrical network may employ a 3 meter long (max.)
extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs is prohibited
because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under or over hot or
sharp surfaces.
• This unit is not designed to be installed in an RV or used with an inverter.
• The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a protective
conductor are prohibited. If in doubt, have the house installation checked over by a qualified
electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing or
damaged protective conductor.
caso WineCase 6
26
Advertenties
Inhoudsopgave
