Advertenties
Beschikbare talen
Beschikbare talen
MT iQ Solar Monitor III
• Do not modify or adapt any of the components in any way.
A
NOTICE! Damage hazard
• Before start-up, check that the voltage specification on the data plate is the same as
that of the power supply.
• Ensure that other objects cannot cause a short circuit at the contacts of the device.
• Ensure that the negative and positive poles never come into contact.
2.2
Installing the device safely
!
WARNING! Failure to obey these warnings could result in death or serious
injury.
Electrocution hazard
• Disconnect the solar panels and the solar charger fuse before installation or removal
of the solar monitor.
• Lay the cables so that they cannot be damaged by the doors or the hood.
Crushed cables can lead to serious injury.
!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Risk of injury
• Ensure that the solar monitor is securely fastened so that it cannot come loose under
any circumstances (sudden braking, accidents) and cause injury to the occupants of
the vehicle.
• When positioning the device, ensure that all cables are suitably secured to avoid any
form of trip hazard.
A
NOTICE! Damage hazard
• Do not place the solar monitor near heat sources (heaters, direct sunlight, gas ovens,
etc.).
• Set up the device in a dry location where it is protected against splashing water.
• Use ductwork or cable ducts if it is necessary to lay cables through metal panels or
other panels with sharp edges.
• Do not lay the 230 V mains cable and the 12 V DC cable in the same duct.
• Do not lay the cable so that it is loose or heavily kinked.
• Do not pull on the cables.
EN
Safety instructions
7
Advertenties
