Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operating manual
Welding bead porous.
Very large spark particles.
No gas at torch outlet
Error when downloading
Backup problem
Automatic deletion of JOBS.
USB key problem
File problem
Update problem
WARRANTY CONDITIONS
The warranty covers all manufacturing defects or faults for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
•Any other damage due to transport.
•Normal wear and tear of parts (e.g. cables, clamps, etc.).
•Incidents due to incorrect use (incorrect power supply, dropping, dismantling).
•Environment-related faults (pollution, rust, dust).
In the event of a fault, return the appliance to your distributor, enclosing:
- dated proof of purchase (till receipt, invoice, etc.)
- a note explaining the fault.
26
Translation of the original
instructions
Gas flow insufficient.
Empty gas cylinder.
Unsatisfactory gas quality.
Air circulation or influence of wind.
Gas nozzle too dirty.
Poor quality of wire.
Poor quality of the surface to be welded (rust,
etc.)
Gas not connected
Arc voltage too low or too high.
Incorrect earth connection.
Insufficient shielding gas.
Incorrect gas connection
The data on the USB key is incorrect or
corrupted.
You have exceeded the maximum number of
backups.
Some of your jobs have been deleted because
they were no longer valid with the new syner-
gies.
No JOB is detected on the USB key
More memory space in the product
The "..." file does not match the synergies
downloaded to the product
The USB key does not seem to be recognised.
The display for step 5 of the update procedure
does not appear on the screen.
P1 - P3 GYS AUTO
Adjustment range 15 to 20 L / min.
Clean the base metal.
Replace it.
Replace it.
Prevent draughts, protect the welding area.
Clean the gas nozzle or replace it.
Use a wire suitable for MIG-MAG welding.
Clean the workpiece before welding
Check that the gas is connected to the gene-
rator inlet.
See welding parameters.
Check and position the earth clamp as close
as possible to the area to be welded.
Adjust the gas flow.
Check the gas inlet connection
Check that the solenoid valve is working
Check your data.
You need to delete programs.
The number of backups is limited to 200.
-
-
Free up space on the USB key.
The file was created with synergies that are
not present on the machine.
1- Insert the USB key into its slot.
2- Switch on the generator.
3- Press and hold down the HMI wheel to
force the update.
Advertenties
Inhoudsopgave
