Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operating manual
Stray welding currents can destroy earth conductors, damage electrical equipment and devices and cause components to
overheat, leading to fire.
- All welding connections must be firmly connected and checked regularly!
- Ensure that the workpiece is securely fastened and free from electrical problems!
- Attach or suspend all electrically conductive parts of the welding source such as the chassis, trolley and lifting systems so that they are insulated!
- Do not place other equipment such as drills, grinding devices, etc. on the welding source, trolley or lifting systems unless they are insulated!
- Always place welding torches or electrode holders on an insulated surface when not in use!
Power supply, extension and welding cables must be completely unwound to avoid overheating.
The manufacturer accepts no responsibility for damage to persons or property caused by incorrect and dangerous use of this
equipment.
MAINTENANCE / ADVICE
•Maintenance must only be carried out by a qualified person. Annual maintenance is recommended.
•Switch off the power supply by pulling the plug and wait two minutes before working on the equipment. The voltages and
currents inside are high and dangerous.
•Regularly remove the cover and blow off the dust. Take the opportunity to have the electrical connections checked with an insulated tool by qualified
personnel.
•Regularly check the condition of the power cord. If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a
similarly qualified person, to avoid any danger.
•Leave the welding power source vents free for air intake and exhaust.
•Do not use this welding current source to defrost pipes, recharge batteries/accumulators or start motors.
INSTALLATION - OPERATION PRODUCT
Only experienced personnel authorised by the manufacturer may carry out the installation. During installation, make sure that the generator is
disconnected from the mains. Do not connect the generator in series or in parallel. It is recommended to use the welding cables supplied with the
equipment in order to obtain optimum product settings.
DESCRIPTION
This equipment is a single-phase power source for semi-automatic "synergic" welding (MIG or MAG). The P1 GYS AUTO accepts Ø 200 and 300 mm
wire reels. The P3 accepts Ø 200 wire reels.
DESCRIPTION OF EQUIPMENT (II)
P1
1-
Reel support Ø 200/300 mm
2-
Accessory box hatch
3-
Cable support
4-
Torch support
5-
HMI (Human Machine Interface)
6-
START/STOP switch
7-
Ground cable (-) 3.5 m
8-
Euro connector (torch X1)
P3
1-
Reel support Ø 200 mm
2-
Accessory box hatch
3-
Cable support
4-
Torch support
5-
HMI (Human Machine Interface)
6-
START/STOP switch
7-
Ground cable (-) 3.5 m
8-
Euro connector (torch X3)
MAN-MACHINE (IHM)
Please read the user manual for the interface (HMI), which is part of the complete equipment documentation.
IHM
Translation of the original
instructions
9-
Gas connector
10-
Mains connection
11-
4m
bottle support
3
12-
Motor hose reel
13-
USB connection
9-
Gas connector
10-
Mains connection
11-
bottle support 2x4m
3
12-
Motor hose reel
13-
USB connection
P1 - P3 GYS AUTO
21
Advertenties
Inhoudsopgave
