Advertenties
Beschikbare talen
Beschikbare talen
5.22 Switch overtime timer on/off
This function provides the option of manually switching to the daytime temperature outside the
set switching times for a period of 1, 2 or 3 hours.
The yellow LED with the symbol
right of the display shows the time in minutes that still remains before the function is deactivated
and the PinTherm Connect returns to night temperature control. The function can also be swit-
ched off prematurely by pressing the push-button again until the yellow LED extinguishes and the
number of remaining minutes disappears from the display.
See the illustration below.
MON
MON
5.23 Switch on chimney-sweep function
You can use this function to switch the appliance temporarily to full heat output/partial heat
output so that measurements can be taken. Refer to the information below for instructions on
how to switch this function on and off. After activation, this function remains switched on for 15
minutes and will switch off automatically again after that period.
0-10V
0
Press and hold down
Use the push-buttons referred to below to have the
for ±12 seconds
appliance run at a lower voltage (reduce the heat output)
5.24 Restore factory settings PinTherm Connect
All the factory settings are restored when you activate this function. This function may be
activated at any time. See the illustration below.
OK
keep pressed or
+/- 12 secs
18
is lit when this function is active. In addition, the bottom
17:01
18°C
NIGHT
17:01
18°C
DAY
X:120
14:59
10V
press to increase the voltage (maximum of 10V)
press to lower the voltage
This switches the function o and takes you back
ESC
to the main screen
RESET TO DEFAULT
SETTINGS?
This will return you to the
ESC
screen from which you
selected this function and
default settings will not be
restored.
MON
17:01
18°C
DAY
X:060
MON
17:01
18°C
DAY
X:180
DEFAULT SETTINGS
RESTORED!
OK
SELECT LANGUAGE
ENGLISH
MON
08:01
DAY
16°C
Advertenties
