Maintainance & Cleaning - Össur RE-FLEX ROTATE Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

MAINTAINANCE & CLEANING

Note: The device should always be used with spectra socks and foot

covers to minimize dust and dirt from entering between carbon blades. It

is important to fix the spectra sock around pyramid location in order to

prevent noise issues coming from sand entering between the plates.

The device is weather-proof but not resistant to corrosion. Therefore, the

device should not come into contact with salt water or clorinated water.

The device is not designed to be used under extreme conditions like

diving or jumping into water. If for some reason the foot components get

wet parts should be dried with a lint free cloth. Should the device come

into contact with salt water, chlorinated water, dust or dirt it must be

rinsed with fresh water immediately.

Note: The stiffness of the shock module can increase in temperatures

below -15 °C (+5 °F).

LIABILITY

The manufacturer recommends using the device only under the specified

conditions and for the intended purposes. The device must be

maintained according to the instructions for use. The manufacturer is

not liable for damage caused by component combinations that were not

authorized by the manufacturer.

COMPLIANCE

This component has been tested according to ISO 10328 standard to two

million load cycles. Depending on the amputee's activity this

corresponds to a duration of use of two to three years. We recommend

carrying out regular yearly safety checks

ISO

Body mass limit not to be exceeded!

For speci c conditions and limitations of use see

manufacturer's written instructions on intended use!

body mass. In these cases, the test loads have been adapted adequately

on the basis of the specified load level.