Download Print deze pagina

CASO DESIGN MCG30Ceramic chef Handleiding pagina 58

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 176
• Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
• Use a properly installed antenna for the receiver, to ensure good reception.
12.10 Assembling the accessories
► The device can be operated with the metal rack and/ or the baking sheet.
► Use the baking sheet only when the
grill/convection is in operation.
12.10.1 Metal rack
• Place the metal rack (as shown) into the device.
• Check that the metal rack is placed correctly.
Attention
► The rubber stoppers must not be removed from
the metal rack.
► Place the metal rack only in the direction shown on the photo.
12.10.2 Baking Sheet
Use the baking sheet as follows:
• Place the baking sheet on the ceramic base plate or the metal rack.
12.11 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
• The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
• The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.
• The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
Please note
58

Advertenties

loading

Deze handleiding is ook geschikt voor:

3371