Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
7.5
Mounting the feed tube
If the feed tube cannot be closed (jamming):
1. Turn the cutting disc 90°.
2. Fold the feed tube back and engage in the
securing lever (central lock).
Danger! Before starting, check that the feed
tube is engaged! The feed tube must be en-
gaged in the central lock.
3. Screw in the securing bolt.
Danger! The securing bolt must not be re-
placed with any other bolt. Use only the origi-
nal securing bolt!
7.6
Care
■
Remove dirt and material residues after ev-
ery use.
■
Do not clean the machine with running water
or high-pressure.
■
Do not use any cleaning agents or solvents.
■
Use a soft brush or cloth for cleaning.
■
To protect the inner side of the housing from
corrosion, spray it with a biologically degrad-
able oil.
Malfunction
Motor does not start.
Machine does not pull in
material to be shredded.
Material to be shredded
is not properly cut.
Motor switches off.
Unusual noises, rattling
in the machine.
10 TRANSPORT
To transport it more easily, the shredder can be
separated in the centre (hinges).
1. Unscrew the nut M8 (01/1).
2. Pull out (01/b) the pull rod (01/2) and remove
the upper section.
22
Possible cause
Mains socket (house installation)
defective.
Extension lead defective.
Obstruction at the cutting unit.
Cutting unit clogged with wet mate-
rial to be shredded.
Blades blunt or damaged
Motor protection switch switched
off due to cutting disk overload or
blockage.
Bolts on the motor, its mounting,
the carriage or the cutting unit are
loose.
8 STORAGE
Clean the shredder after its use. Store it in a dry,
lockable place out of the reach of children.
Perform the following tasks when storing during
the winter period:
1. Switch off the machine and disconnect it from
the mains power supply.
2. Wait for the cutting disk to come to a stand-
still.
3. Unscrew the locking screw and remove the
housing.
4. Remove coarse and wet material from the in-
side of the shredder.
5. Close the housing and tighten the locking
screw.
6. Store the shredder upright.
9 HELP IN CASE OF MALFUNCTIONS
NOTE For malfunctions that are not listed
in this table or that you cannot resolve yourself,
please contact our customer service.
Solution
Use a different mains socket in the
house.
Inspect the lead and replace it, if
necessary.
Remove material from the cutting
unit, if necessary.
Clear the clogging by feeding branch
material.
Turn or replace the blades.
The motor can be switched on again
after a cool-down phase of approx.
five minutes.
Re-tighten bolts.
TCS 2500 | TCS Duotec 2500 | TCS Duotec 3000
Storage
Advertenties
Hoofdstukken
Inhoudsopgave
