Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The shower system may only be used for bathing,
hygienic and body cleansing purposes.
Children as well as adults with physical, mental and/
or sensoric impairments must not use this shower
system without proper supervision. Persons under
the influence of alcohol or drugs are prohibited from
using this shower system.
The hot and cold supplies must be of equal pressu-
res.
Installation Instructions
The fitting must be installed, flushed and tested after the
valid norms!
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow by 0,3 MPa:
anti-pollution function
Do not use silicone containing acetic acid!
Safety Function (see page 62)
The desired maximum temperature for
example max. 42º C can be pre-set thanks
to the safety function.
English
max. 1 MPa
0,1 – 0,5MPa
1,6MPa
max. 80°C
65°C
approx. 58 l/min
Assembly see page 60
Adjustment (see page 63)
After the installation, the output temperature
of the thermostat must be checked. A
correction is necessary if the temperature
measured at the output differs from the
temperature set on the thermostat.
Maintenance (see page 64)
•
To guarantee the smooth running of the
thermostat, it is necessary from time to
time to turn the thermostat from total hot
to total cold.
•
The mixer is equipped with non return
valves. The non return valves must be
checked regularly according to DIN
EN 1717 in accordance with national
or regional regulations (at least once a
year). At this time, please also check the
filter (A) situated on the BTC-thermoele-
ment (96633000). After assembling the
BTC-thermoelement, it is necessary to
check the water temperature at the take
off point as described under the headline
„adjustment". Before the adjustment,
please check, if the warm water supply is
activated and the maximum temperature
of the warm water is available at the take
off point.
Dimensions (see page 66)
Spare parts (see page 67)
Operation (see page 68)
Advertenties
Inhoudsopgave
