Advertenties
Beschikbare talen
Beschikbare talen
After cleaning the interior space, leave the device door open until the interior of the
device is completely dry.
Front of device and operating panel
Clean the front of the device and the operating panel with a soft, slightly damp cloth.
Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth for
cleaning.
Leave the device door open to prevent the device from being re-started accidentally.
Exterior housing
Clean the exterior surfaces of the device with a damp cloth.
Rotating plate, rollring ring and metal rack
The glass turntable and the metal rack must be removed and cleaned occasionally.
Wash the plate and the rack in a warm soapy solution or in the dishwasher.
The rolling ring should be cleaned regularly to prevent excessive noise development or a
rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
Wipe the bottom of the device with a mild cleaning agent. If the floor of the device is
excessively dirty, you can use a mild cleaning agent.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
17.1 Safety notices
Attention
Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
Improperly performed repairs can cause considerable dangers for the user and damages to
the device.
17.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error
The selected program
will not start.
The turntable turns
jerkily.
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable and
the base of cooking camber
Action
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
68
Advertenties
