Advertenties
Beschikbare talen
Beschikbare talen
Electrical hazard. Keep a minimum dis-
tance of 10 m away from overhead lines
10m
when working with the device.
Danger due to flung objects. Keep spec-
tators, especially children and pets, at
least 15 m away from the work area.
Keep your hands away from the blades.
Description of the device
The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
See graphics page for illustrations
Illustration A
Trigger
1
Trigger lockout button
2
Handle housing
3
Type plate
4
Battery pack unlocking button
5
Cutting blade
6
Hook
7
Blade guard
8
*Quick Charger Battery Power 18V
9
*Battery Pack Battery Power 18V
10
* Not included in the scope of delivery
Rechargeable battery pack
The device can be operated with a 18 V Kärcher Bat-
tery Power battery pack.
Initial startup
Removing the blade guard
1. Remove the blade guard.
Illustration B
Mounting the hook
1. Mount the hook using a suitable Phillips screwdriver.
Illustration C
Installing the battery pack
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
Illustration D
Basic operation
1. Check the tree and the branches to see if any dam-
age such as rot is present or if the branches are un-
der tension.
2. Hold the device firmly with both hands.
Illustration E
3. Use the hook to remove loose bark or branches.
Illustration F
Switch on the device
1. Press the trigger lockout button.
Illustration G
2. Press the trigger.
The device starts up.
3. Release the trigger.
The device stops.
Removing blockages
Wood chips or bark can lead to blockage of the cutting
blades.
WARNING
Removing blockages
Incision injuries from the sharp blade or sharp-edged
objects
Wear protective gloves when checking for blockages or
removing blockages.
1. Press the trigger 3 - 4 times.
If the blockage cannot be removed, proceed as follows:
2. Remove the battery pack (see Chapter Removing
the battery pack).
3. Gently tap the cutting blade with a piece of wood or
a rubber mallet until the blockage is released. Keep
your hands away from the cutting blades as the
blades suddenly open after removing the blockage.
Illustration H
4. Check that the blades are free to move, if necessary
clean foreign bodies from the blades using a brush.
5. Mount the battery pack (see Chapter Installing the
battery pack).
6. Before further cutting, press the trigger to fully open
the blades.
Illustration G
Removing the battery pack
Note
During longer work breaks, remove the battery pack
from the device and secure it against unauthorised use.
1. Pull the battery pack unlocking button in the direc-
tion of the battery pack.
Illustration I
2. Press the battery pack unlocking button to unlock
the battery pack.
3. Remove the battery pack from the device.
Finishing operation
1. Remove the battery pack from the device (see
Chapter Removing the battery pack).
2. Clean the device (see Chapter Cleaning the de-
vice).
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
CAUTION
Uncontrolled startup
Incision injuries
Remove the battery pack from the device before trans-
port.
Transport the device only with the blade guard fitted.
Secure the device against slipping and tipping over
when transporting in vehicles.
English
Transport
15
Advertenties
Hoofdstukken
