Advertenties
Beschikbare talen
Beschikbare talen
Mode of Operation
(Display OFF)
Remove
Connect
Remove
battery
battery
battery
Mode of Operation
(Display ON)
Press
Press
Press
channel selection keys
channel selection keys
channel selection keys
for approx. 5 s.
for approx. 5 s.
for approx. 10 s.
Learn Mode
Erase Mode
(1st Decimal Point ON)
(1st & 2nd Dec. Points ON)
22
Commissioning of radio components
The Radio Receiver has three different
modes of operation:
1. Service mode
Radio telegrams from transmitters
learned in are converted into EIB
telegrams. => Normal mode.
Remove
battery
2. Learning mode
Radio control transmitters and
functions are learned. Receiver
sensitivity is highly restricted to avoid
erroneous learning events.
3. Clear mode
Radio control transmitters and
functions are deleted.
Changing the Modes of Operation
You can change between the modes as
shown in the opposite diagram. For this
purpose, the battery must be connected
to clip B.
To learn radio components and to
assign keys (functions) to an ETS
channel number the learn mode must
be activated first.
Learning Mode
In the learning mode, the keys or devices
of the radio products are learned and
assigned to an ETS channel number.
Changing to learn mode:
1. Connect the battery to clip B (see
illustration on fold-out page). Display
J is activated.
2. Press channel selection keys G and
H simultaneously until display J
shows '01' and the right decimal
point is lit up (ca. 5 seconds).
Learning a new key or a new device,
respectively:
1. Set desired ETS channel number
with channel selection keys G and H.
2. Actuate radio control transmitter until
display reads 'LE' (LEARN).
(Actuation time: between 1 s and 10 s:
e. g. 1 s for channel keys, 10 s for All-
ON or All-OFF key, respectively.)
3. To store the key or the device on the
ETS channel set before press accept
key D. Learning will be indicated by
the channel number shortly blinking
in display J.
Cancel process: Press channel selections
keys G and H simutaneously until the right
decimal point in the display goes out.
To have further devices or keys learned
in start from item 1 again.
Important: If all 100 memory locations
are occupied in the device the display
will read 'OF' (OVERFLOW).
Relearning a key or device, respectively,
into a new channel:
1. Set desired new ETS channel
number with channel selection keys
G and H.
2. Actuate radio sensor. Channel number
still current will be blinking in display J.
(Actuation time: between 1 s and 10 s:
e. g. 1 s for channel keys, 10 s for All-
ON or All-OFF key, respectively.)
3. To program the device or key to a
new ETS channel accept key D must
be pressed for approx. 3 s.
Programming the device to the new
ETS channel number will be indicated
by this channel number shortly blinking.
Cancel process: Press channel selections
keys G and H simutaneously until the right
decimal point in the display goes out.
To return to the normal service mode after
the learning processes remove the battery.
23
Advertenties
