2 . Move the tip
socket-outlet) . If the red LED flashes and the built-in buzzer
beeps once, the product can be used .
Detecting AC voltage
1 . Check if the product his still switched on (The green LED
remains on) .
2 . Move the tip
When the product detects AC voltage, the red LED
flashes and the buzzer beeps once . The closer you move
the product to the wire or socket, the higher the flashing
frequency of the red LED and the beeping frequency of the
buzzer .
Switching off: Press the
o
LED goes off . The buzzer beeps twice .
NOTES:
The tip
[
6 ]
o
For different wires or sockets to be tested, the product's
o
detection sensitivity may be different . This is normal .
If the buzzer has been disabled, the product will not beep
o
during detection (see "Disabling the buzzer's beep sounds
during operation") .
Flashlight
Turning the flashlight on: Press and hold the button
o
Turning the flashlight off: Release the button .
o
Cleaning and care
Do not allow liquids to enter the product . Otherwise the
o
product may be damaged .
Do not use abrasive cleaning agents, cleaning alcohol or
o
other chemical solutions since these could damage the
housing or even impair operation .
Use a dry, lint-free cloth for cleaning .
o
The product is maintenance-free . No components need to
o
be maintained by you inside the product .
Keep the product clean to ensure fault-free operation .
o
Storage
Always store the product in a dust free environment .
o
Always remove the batteries if the product will not be used
o
for extended periods .
Store the product in a dry location .
o
close to a known AC voltage (such as a
6 ]
[
close to the wire or socket to be tested .
6 ]
[
must be close enough to the object to be tested .
button
again . The green
1 ]
[
.
[
2 ]
GB/IE/NI
13