Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
♦
Proceed in the same way with the other rivets
.
♦
Empty the pin collector
♦
When you have finished working, disconnect
the appliance from the compressed air source .
Maintenance and cleaning
WARNING! RISK OF INJURY! Discon-
nect the appliance from the com-
pressed air supply.
CAUTION!
►
Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the appliance .
Avoid all skin contact with these substances .
If the skin comes into contact with hazardous
dusts, this can lead to severe dermatitis .
►
The dust and vapours produced by using
the appliance can be hazardous to health
(e .g . cause cancer, birth defects, asthma
and/or dermatitis); it is essential to carry out
a risk assessment in respect of these risks
and to implement corresponding regulatory
mechanisms .
NOTE
To ensure correct functioning and long-term
durability of the rivet gun, pay attention to the
following points:
■
Sufficient and continuously intact oil lubrication
is highly important for optimum functioning .
■
Use only the genuine replacement parts rec-
ommended by the manufacturer, otherwise you
could put users at danger . In doubt, contact the
Service Centre .
■
Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of the rivet gun .
■
Only clean the appliance with a soft, dry cloth
or with compressed air .
■
Never use sharp or scratchy cleaning agents
under any circumstances .
PDBNP 14 B1
regularly .
Changing the gripper jaws
Friction can wear out the gripper jaws
happens, replace the worn gripper jaws
the supplied spare gripper jaws
♦
Unscrew the front connector
sembly spanner
, if necessary . This gives you
access to the following parts:
A B
C
E
A
Appliance shaft
B
Lock nut
C
Lock washer
E
Two-piece metal cone
G
Gripper jaws
♦
Unscrew the two-piece metal cone (E) holding
the gripper jaws (G) from the shaft (A), using
the two assembly spanners
sary .
♦
Using both assembly spanners,
unscrew the front piece of the metal cone from
the back piece (E2, E1) . This gives you access
to the following parts:
A B C
D
A
Appliance shaft
B
Lock nut
C
Lock washer
D
Spring
E1
Back piece of the metal cone
F
Expanding mandrel
G
Gripper jaws
E2
Front piece of the metal cone
♦
Remove the expanding mandrel (F) and the
worn gripper jaws (G) from the front piece of
the metal cone (E2) .
. If this
with
as follows .
using the as-
G
and
if neces-
and
,
E1
F
G
GB │ IE │ NI
│
7
E2
■
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
