Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Commissioning
First wrap a piece of Teflon tape (not included)
around the outer threads of the plug nipple
and the lubricator
Now screw the plug nipple
of the lubricator
11
Tighten this connection with moderate force
and absolutely using pliers.
Now turn the combination of lubricator
plug nipple
into the connection thread
9
of the impact driver (see Fig. C).
Also retighten this connection with pliers.
Now press the air hose onto the plug nipple
using a little force, until the hose locks in.
ATTENTION! Be sure the air hose
is firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two screw
connections between lubricator
and machine are securely seated.
Adjusting the compressed air
Note: this device is designed for an operating
pressure of up to 6.3 bar and a compressor with
the minimum air flow specified in the technical spe-
cifications. When setting the air pressure, remember
the pressure drops by approx. 0.6 bar with a hose
length of 10 m and an inside diameter of 9 mm.
Only use filtered, lubricated and regulated
compressed air.
Adjusting the torque
Set the torque control
by pressing it toward the housing and turning it
until it locks at the desired setting.
Be sure the operating pressure of the compres-
sor is between 5 and 6.3 bar.
Note: the ideal pressure is 6.3 bar. The maximum
torque cannot be reached at a pressure of only 5
bar or with insufficient air flow.
54 GB
73786_par_Druckluft-Schlagschrauber PDSS 310 A1_content_LB2.indd 54
All manuals and user guides at all-guides.com
9
(see fig. B).
11
into the thread
9
(see Figure C).
and
11
2
9
, coupling
11
to the correct torque
3
Initial use
Activate the trigger
to start the equipment.
4
Release the trigger
to deactivate the equip-
4
ment.
Setting
1
(low, min.)
2
(normal)
3
(high)
4
(extra high,
max.)
Changing rotation
ATTENTION! The device must come to a
complete standstill before changing the direc-
tion of rotation.
ATTENTION! A machine rotating in an unex-
pected direction can be dangerous. Always
pay attention and use care.
Note: The impact driver clockwise / counter-
clockwise rotation. Use the reverse switch
to change the direction of the impact driver.
Pull the bolt forward in the direction of the „F"
marking („Forward / Fasten") for clockwise
operation. You can now e.g. tighten screws.
Push the bolt back towards the „R" marking
(„Reverse / Release") so it protrudes from the
back of the equipment to set to counter-clock-
wise mode. You can now e.g. loosen screws.
Correctly holding the
equipment
This equipment weighs 2.3 kg.
Hold the equipment with both hands to ensure
safe operation (see Fig. D and E).
6
30.05.12 17:00
Advertenties
Hoofdstukken
Inhoudsopgave
