Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance.
WARNING! Do not close the ventilation openings in the device housing.
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
13.5.2
Feet
There are different feet (3 bigger feet and 1 small foot).
To level your appliance, adjust the small foot at the bottom of the appliance.
13.5.1
The handle installing
The wine cooler comes with one metal
stainless steel handle. To install simply
screw them to the door with the supplied
screws.
To do this, slide the rubber seal on the back
of the door to the side to lay open the
predrilled holes. Use the included screws to
install the handle on the door.
Then reinsert the rubber seal in the correct
position.
13.5.2
To remove a shelf
Remove all bottles from the shelves. Lift the
shelf upwards and the gently pull it out,
(eventually untighten the screws).
► Ensure that the shelves are firmly engaged in place before storing any bottles.
► Pay attention for a uniform disposition of the bottles in the device.
Please note
30
Advertenties
Inhoudsopgave
