Advertenties
Beschikbare talen
Beschikbare talen
22
Operation
EN
fLO
USER MANUAL
With the Flow Control Sensor, the efficient and healthy operation of the cooling
Flow Control Sensor
system is controlled. If there is a problem in the water circulation, the user is warned
with an error code.
• On - Off
Setting Range
When the cooling unit is not used, the FLO setting should be in the OFF position.
Trigger mode selection will be made. Each time the button is pressed, the other
Trigger Mode Selection
trigger mode is switched.
• 2 Trigger
Setting Range
• 4 Trigger
• Spot (Method)
2 TRIGGER MODE : When the torch trigger is pressed, welding starts and the trigger
Press the Trigger
will be held pressed until the welding ends. Releasing the trigger will end the welding.
• Press and hold the torch trigger.
Welding Start;
• Shielding gas flow starts as long as the pre-gas period.
• At the end of the pre-gas period, the wire feed motor runs at a slow speed.
• Welding current increases when the workpiece is reached.
• Release the pressed torch trigger.
Welding Termination;
• The wire feed motor will stop.
• The arc extinguishes after the set burn-back time.
• The process ends after the final gas period.
Hold the Trigger Pressed
COMPACT ECO SERIES
Release Trigger
PrG : Initial Gas Time
: Welding Current
PoG : Final Gas Time
I
www.magmaweld.com
Advertenties
