Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Or correspondingly press the V-button
on or off.
Crossed lines can be locked with this product:
When the product is performing automatic levelling and the base
of the measurement device deviates from the horizontal by less than
4° (green LED on) hold down the H-button
tor
goes red. Now automatic levelling is switched off and the
2
crossed lines are permanently switched on - even if the base of the
measurement device deviates from the horizontal by more than 4°.
You can turn this mode off again by pressing and holding down the
H-button
1
tomatic levelling system has been switched on again.
The crossed lines are turned off as soon as the base of the measuring
tool deviates from the horizontal by more than 4°, and the LED indica-
tor
will turn red again.
2
Working without the automatic
levelling system
Put the LOCK switch
Hold down the H-button
on. Now the product will release two laser lines from the laser
beam opening
levelling will always be indicated via the red LED indicator
14 GB/IE/NI
until the LED indicator
into the position .
3
until the red LED indicator
1
that are not levelled. Operation without automatic
7
to turn the vertical line
4
until the LED indica-
1
goes green again. The au-
2
comes
2
.
2
Advertenties
Hoofdstukken
Inhoudsopgave
