Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Noise emission value:
Noise measurement determined in accordance
with ISO 15744 .
The rated noise level of the tool is typically:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear hearing protection!
Total vibration value:
Vibration values determined in accordance with
ISO 28927-6 and EN 12096:
Vibration emission value a
Uncertainty K
= 0 .59 m/s
h
NOTE
►
The noise emission levels and vibration values
specified in these instructions have been mea-
sured in accordance with the corresponding
standardised measuring procedure and can
be used to make equipment comparisons .
The noise emission levels and vibration values
vary depending on the use of the compressed
air tool and may be higher than the values
specified in these instructions in some cases .
It is easy to underestimate the noise emission
levels and vibration values if the compressed
air tool is used regularly in this manner .
PDBNP 14 A1
L
=
76 .1 dB (A)
pA
K
=
3
dB
pA
L
=
87 .1 dB (A)
WA
K
=
3
dB
WA
≤ 0 .85 m/s
2
h
2
General safety instruc-
WARNING!
tions for
compressed air tools
WARNING!
►
For multiple hazards: Please ensure that you
have read and understood the safety instruc-
tions before adjusting, operating, repairing,
maintaining or replacing any accessories
on the rivet gun and before working in the
vicinity of the machine . Failure to do this can
result in serious bodily injury .
■
The rivet gun should only be adjusted, set or
used by adequately qualified and trained op-
erators .
■
This rivet gun may not be modified . Modifi-
cations can reduce the effectiveness of the
safety measures and increase the risks for the
operator .
■
Do not lose the safety instructions – give them
to the operator .
■
Never use a damaged rivet gun .
■
The appliance must be inspected regularly to
ensure that it is labelled with the required rated
values and markings given in this manual . The
user must contact the manufacturer to obtain
replacement labels if necessary .
Hazards caused by flying parts
■
If a workpiece or accessory breaks, parts can
be flung out at high speeds .
■
Always wear impact-resistant eye protection
when operating the rivet gun or exchanging
accessories on the appliance . The degree of
necessary protection must be evaluated sepa-
rately for each individual task .
■
Wear a safety helmet if working above head
height . In this case, the risks for others should
also be assessed .
GB │ IE │ NI
│
3
■
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
