Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Refilling oil
To ensure that the rivet gun remains operational for
as long as possible, make sure that there is sufficient
pneumatic oil in the appliance .
You have the following options:
♦
Attach a maintenance unit with an oiler to the
compressor .
♦
Install a fitted oiler into the compressed air line
or the compressor .
♦
Manually add 3–5 drops of pneumatic oil from
the supplied oil container
nipple
after every 15 minutes of operation .
♦
When opening the oil container
time, remove the cap nut from the container .
Use a pair of long-nosed pliers or a similar
implement to remove the internal pipette .
♦
Turn it 180°, replace it and screw it back in
place with the cap nut .
♦
Use a needle or similar tool to poke a small
hole into the tip of the pipette to release oil .
Connecting to a compressed air
source
NOTE
►
Before connecting the compressed air source,
–
the correct working pressure (3–6 bar)
must be fully reached
–
ensure that the trigger
♦
Pull the supply hose connector over the quick-re-
lease fastener on the connecting nipple
it clicks into place .
NOTE
The compressed air source must be equipped with
a pressure reducer to ensure that you can regulate
the air pressure .
PDBNP 14 A1
into the connecting
for the first
is not pulled
until
Use
♦
The appliance is ready for use as soon as the
pneumatic air flow has been established .
♦
Screw the pin collector
the pin collector
♦
Determine the suitable rivet size on the basis of
the workpieces used .
♦
Use a suitable tool to drill a hole into the work-
pieces in the spot where the rivet
located . Make sure the diameter of the hole
corresponds to the determined rivet size .
CAUTION!
►
Suitable safety precautions must be taken
depending on the size and nature of the
workpieces . Use suitable clamping devices to
prevent the workpieces from slipping .
►
In the event of an interruption to the air sup-
ply, release the trigger
►
Before switching on the machine, make sure
the machine tool is firmly placed on the
surface to be processed .
♦
Check if the diameter of the attached mouth-
piece
matches the mandrel diameter of the
determined rivet size .
♦
If it does not, unscrew the front connector
using the assembly spanner
CAUTION!
►
Ensure that the appliance is disconnected
from the compressed air source before you fit
or remove the front connector
♦
If necessary, unscrew the mouthpiece
front connector
using the assembly spanner
. Afterwards, screw the correct
spare mouthpiece
and tighten it .
♦
To attach the front connector
the thread (you will feel minor resistance) and
tighten it by hand .
♦
Tighten the front connector
bly spanner
.
♦
Reconnect the appliance to the compressed air
supply .
onto the thread for
at the back of the machine .
will be
immediately .
, if necessary .
.
from the
into the front connector
, press it onto
using the assem-
GB │ IE │ NI
│
7
■
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
