Inhoudsopgave
Advertenties
Make sure the cutting disc cannot get jammed or laterally stressed while
cutting. The cutting disc must be inserted straight into the cutting gap of the
workpiece.
Always try to cut the workpiece in one go.
ON/OFF Switch
1. To turn the angle grinder on, push the safety button (4) and then press the
ON/OFF switch (5). The angle grinder starts up.
To switch off the angle grinder, release the ON/OFF switch.
Speed Regulator
With the speed regulator (3) you can regulate the speed of the angle grinder as
required.
Hints for Operation
When using the angle grinder for cutting, avoit tilting the angle grinder out of
the cutting line. It is advisable to use diamond discs when cutting hard stone.
For the best results while rough grinding hold the machine against the surface
in an angle between 30° and 40° in smooth, even movements.
The maximum permitted speed of the disc must be equal to or higher than
the maximum no load speed of the machine. The maximum permitted speed
of the cutting disc is printed on the disc.
Use only cutting or grinding discs with a maximum permitted rotation speed
of 6600 revolutions per minute.
Never cut materials containing asbestos with this angle grider.
Carbon Brushes
The angle grinder is delivered with a spare set of carbon brushes. Carbon
brushes should only be replaced by a professional. Or questions please turn to
the Westfalia customer service.
Maintenance and Cleaning
Before undertaking any cleaning or maintenance work on the machine, pull
the power plug.
Keep the machine clean. Make sure the ventillation slots are always clean and
free from obstructions. Clean the angle grinder with a soft cloth, which may
be slightly moistened at the utmost.
Do not immerse the machine in liquids of any kind and do not allow liquids to
enter the machine.
Store the amgle grinder in a dry place
22
Advertenties
Inhoudsopgave
