Inhoudsopgave
Advertenties
Fig. A
Make sure the cutting disc rotates in the direction of rotation (9) printed on
the machine housing.
After installing a disc perform a brief test run. Discs which cause vibrations
and run unround must be replaced immediately.Keep the disc away from
moisture and oil and protect it from either hitting or severely bumping against
any object.
Bever attach saw blades or saw chains! Such devices may cause
unpredictable kickback!
Using the Safety Hood for Grinding Discs (7)
The safety hood should be aligned is such a way that it protects you from
sparks and flying debrie.
1. Loosen the safety hood locking lever (10) and turn to the desired position.
2. Tighten the safety hood in this position.
Using the Safety Hood for Cutting Discs (1)
1. Remove the safety hood for grinding discs (2).
2. Attach the safety hood for cutting discs (1) on the angle grinder.
When using cutting discs with the angle grinder, always use the safety hood
(1) that has been designed for use with cutting discs.
Please note that after work the cutting disc and the workpiece become very
hot. There is risk of burns! Make sure always to use the right cutting disc for
the job.
When using the angle grinder for cutting, avoit tilting the angle grinder out of
the cutting line. It is advisable to use diamond discs when cutting hard stone.
For the best results while rough grinding hold the machine against the surface
in an angle between 30° and 40° in smooth, even movements.
Never cut materials containing asbestos with this angle grider.
Secure the workpiece and place suitable wedges under the workpiece. When
operating the angle grinder, do not press the cutting disc too much on the
workpiece. The self weight of the angle grinder is enough to perform the cut.
Avoid overheating the cutting disc; allow the disc to cool down sufficiently.
Fig. B
21
Advertenties
Inhoudsopgave
