Inhoudsopgave
Advertenties
Before first Use
Remove the angle grinder and the accessories for the packaging. Keep
packaging material out of reach of children. There is risk of suffocation!
Intended Use
This angle grinder is intended for cutting and grinding metal and stone with the
suitable discs.
Setup
Please make sure the power mains voltage corresponds to the operating
voltage stated on the type label.
Attaching the Auxiliary Handle
Do not operate the angle grinder without the auxiliary handle (2). There are
two threaded mounting holes (6) in the transmission housing, one in each side
and one in the middle, to which the auxiliary handle (2) can be attached.
Inserting/Changing the Grinding Disc
Please Note! Always pull the power plug before changing a disc to avoid
accidental starting.
1. Lossen the outer flange with the included face wrench. Keep the shaft lock
(8) pressed to lock the drive shaft and the disc.
2. Insert the cutting disc resp. replace the worn disc. Make sure to attach the
inner flange first, then the cutting disc and finally the outer flange.
3.
Shaft Lock (8)
Safety Hood (1/6)
Inner Flange
Grinding Disc
Outer Flange
For discs up to 3 mm strong install the outer flange with the flat side to the disc
(Fig. A), for discs stronger than 3 mm install the outer flange with the stepped
side to the disc (Fig. B).
OPERATION
20
Advertenties
Inhoudsopgave
