Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. Getting Started
4.1 Measuring station
• Remove the screen protector from the display.
• Open the battery compartment (26) and insert two AA batteries
with the correct polarity.
• Move the CH slide switch (25) to the left or right to select the
channel on which the measuring station transmits. (22) CH1, CH2
or CH3 is displayed. Once the channel has been assigned to a
transmitter, it can only be changed by removing the batteries or by
resetting the base station (see section 6.9 Reset).
• The measured temperature and humidity values are displayed in
alternating fashion.
• Close the battery compartment cover.
• Close the battery compartment.
Note
Before use, ensure you insert the batteries in the measuring station
rst and then in the base station.
4.2 Base station
• Remove the screen protector from the display.
• Open the battery compartment (20) and insert two AA batteries
with the correct polarity.
• Close the battery compartment.
5. Installation
Note – Installation
• We recommend initially placing the base and measuring
stations in the intended locations without installing them and
making all the settings described in
6. Operation – to do.
• Only install the stations once the appropriate settings have
been made and a stable wireless connection is established.
Note
• The wireless transmission range between the measuring
and base stations is up to 50 m in open spaces.
• Before installation, ensure that wireless transmission will not
be disrupted by interference or obstacles like buildings, trees,
vehicles, high-voltage lines, etc.
• Before the nal installation, ensure that there is su cient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air temperature
is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a specialised
dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage the
product.
• Before installation, ensure that the chosen wall is suitable for
the weight to be mounted, and make sure that there are no
electrical wires, water, gas or other lines at the installation
site on the wall.
• Do not mount the product above locations where persons
might linger.
5.1 Base station
• Use the base to position the base station on a level surface.
5.2 Measuring station
• You can also position the measuring station on a level outdoor
surface.
• We recommend installing the measuring station securely on an
outdoor wall using the opening (23).
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang the measuring station using the opening intended for this
purpose (23).
6. Operation
Note – Input
Hold down the CH+ button (13) or the MEM– button (17) to
select the values faster.
6.1 Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and performs
initial setup.
Note
• Initial setup takes approx. 5 minutes.
• During connection, the wireless symbol on the measuring
station radio symbol will ash (7).
• Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors
and inaccuracies.
• The setup process is completed when the indoor (2, 3) and
outdoor (8, 9) measurement data is displayed.
• If the base station still does not receive a signal from the
measuring station, press the SENSOR button (15) to start the
manual search for the signal. During the connection attempt, the
measuring station radio symbol (7) will ash.
• During the manual search, press and hold the SENSOR button
(15) for approx. 3 seconds to end the search. The radio symbol
(7) disappears.
3
Advertenties
Inhoudsopgave
