Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INTERIOR AND EXTERIOR CLEANING
•
Regularly remove the dust from the back panel and side plates of the appliance. Use a dry cloth for this (no water).
•
If the appliance will not be used for several months, switch it off, unplug it from the socket, clean and dry it
and leave the door open to prevent mould forming in the appliance. For more information on switching off and
storage, see Section 7.
6. TROUBLESHOOTING
You can solve some problems easily yourself using the table below. If the following descriptions do not solve your
problem, please contact our customer service: wisberghome.com
Only an authorised service technician may solve the malfunctions that are not listed in this manual. Repairs carried
out by unauthorised persons may cause injury and/or serious damage to persons and property.
PROBLEM
The appliance
does not cool at
all.
The
temperature in
the appliance is
too low/high.
POSSIBLE CAUSE
- The control knob for the
temperature is wrong.
- The plug is not inserted properly.
- There is no voltage on the socket.
- The fuse is blown or defective.
- The appliance is installed in
a place where the ambient
temperature is less than 10°C,
such as a balcony, garage or
storage room.
- The power has failed.
- The temperature is not set
correctly.
- The door is not closed properly.
- The temperature of the food is too
high.
- Many products are stored at the
same time.
- The door has been opened too
often.
SOLUTIONS
- Set the thermostat to another position.
- Insert the plug properly.
- Open the door and check if lamp is on. If
the lamp is off, there may be no voltage on
the socket. Have the socket repaired by an
electrician.
- Check the fuse and replace if necessary.
- Install the appliance in a protected location
where the ambient temperature is higher
than 10°C. If the appliance is installed in
a room with too low a temperature, the
internal cooling system may not operate
correctly.
- Try to open the door of the appliance as
little as possible to keep the food safe and
fresh for hours. If you know about the power
failure beforehand: Set the thermostat button
in the high mode an hour in advance, so
that the food is frozen completely. (Do not
add any other food to freeze during this
period!) Set the temperature mode back to
the original setting in good time when the
power supply is restored.
- Set a higher/lower temperature.
- Find the cause of the door not closing
properly, remove or move possible
obstacles.
- Allow the food to cool to room temperature
before preserving.
- Preserve fewer products at the same time.
- Only open the door if necessary.
29
Advertenties
Hoofdstukken
Inhoudsopgave
