Advertenties
Beschikbare talen
Beschikbare talen
D15, D50, D52
7.3
Reversing the door
You can also change the hinge of the door, so that it opens to the left rather than the
right.
Then fit the door handle on the other side, see chapter "Fitting the door handle on
the other side" on page 17.
➤ Change the door as described in fig. 3, page 4 to fig. 7, page 5.
Fitting the door handle on the other side
➤ Fit the door handle on the other side as described in fig. 8, page 5 to fig. 9,
page 5.
7.4
Information on electrical connection
A
NOTICE!
Leave the appliance to stand upright for about 2 hours after transporting,
before you connect it to the power supply.
Otherwise this could cause faults in the cooling system.
Observe the following when connecting the appliance:
Connect the appliance to a separate circuit that is protected with 15 A.
Have the socket and power circuit checked by a qualified electrician to ensure
that the socket is earthed correctly.
Check that the voltage specification on the type plate is the same as that of the
power supply.
If you use an extension cable, this must be approved for the same values as the
appliance, see chapter "Technical data" on page 28.
Do not use an extension cable or a multiple power socket that can be switched
off with just one switch.
The cable must rest securely behind the appliance and not be allowed to lie or
hang unprotected.
EN
Setting up and connecting the appliance
17
Advertenties
